Panasonic NV-HD100EA - Manual (Page 33)

Before Requesting Service
SYMPTOM ■ 'CAUSE-.V:.’^ ‘A'- REMEDY .CHjEcicpor.
Remote controller
does not operate
correctly.
Remote controller transmitter
beam is not reaching VTR. Ensure that remote controller is being pointed at VTR
and that transmitter beam is not obstructed.
Distance is too far. Use remote controller within 7 m of VTR. If this range
is not possible, replace batteries.
Batteries are exhausted. Replace batteries. Note precaution for replacement
on page 13.
Batteries are incorrectly fitted
with (+/-) reversed. Fit batteries correctly as shown on page 13.
Bar code reading is
not possible. Remote controller is in power
saving condition.
Press SCANNER ON/OFF to turn it on again.
Bar code is not traced
correctly. Practice tracing the bar code from left to right. Each
bar code should take around half a second to trace. A
beep indicates bar code is read correctly.
Bar code sensor cap is
blocked. Remove sensor cap and clean as shown on page 27.
Bar code data
cannot be
transmitted to VTR. VTR is operating. Stop VTR.
Timer record memory is full. Cancel timer programme to enter a new timer
programme or wait until one timer recording has
taken place.
Bar code reading is not
followed by a repeated bleep. Read bar code again.
o
c
5
Q
'Z
I
33