Rear panel, 1) antenna terminals, 2) audioa/ideo jacks – Yamaha RX-497 User Manual
Page 10: 3) sub woofer output jack, 4) remote jacks, 5j xm jack, U.s.a. model only), 6) cd jacks, 7) phono jacks and gnd terminal, Zone 2 jacks
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS AND FUNCTIONS
Rear panel
(1)
Antenna terminals
Connect FM and AM antennas.
See page 12 for connections information.
(2)
AUDIOA/IDEO jacks
Connect audio and video components.
See page 10 for connection information.
(3) SUB WOOFER OUTPUT jack
Connect a subwoofer with built-in amplifier.
(4) REMOTE jacks
These jacks are used to input/output remote control
signals.
See page 37 for connection information.
(5j XM jack
(U.S.A. model only)
Connect XM Connect-and-Play digital antenna accessory.
See page 26 for connection information.
(6) CD jacks
Connect a CD player.
See page 10 for connection information.
(7) PHONO jacks and GND terminal
Connect a turntable.
See page 10 for connection information.
® ZONE 2 jacks
C'onnect a Zone 2 component.
See page 37 for connection infomiation.
(9) SPEAKERS terminals
Connect speakers.
See page 11 for connection infomiation.
® IMPEDANCE SELECTOR switch
Switches the impedance setting.
See page 11 for details.
(
11
) AC OUTLET(S) (SWITCHED)
FIse to supply power to your other audio and video
components.
See page 14 for details.
■ Asia and General models only
VOLTAGE SELECTOR
VOLTAGE SELECTOR on the rear panel of this unit must
be set for your local main voltage BEFORE plugging the
pow'er supply cord into the AC wall outlet.
Voltages are as follow's:
Asia model........................ AC 220/230-240 V 50^60 Hz
General model..... AC 110/120/220/230-240 V 50/60 Hz