Preliminary steps, If you suspect something wrong, Troubleshooting tips – Panasonic CQ-DP171U User Manual
Page 32: Troubleshooting, Common
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Troubleshooting
Preliminary Steps
Check and take steps as described in the tables below.
If You Suspect Something Wrong
Immediately switch power off.
Disconnect the power connector and check that there is neither
smoke nor heat from the unit before asking for repairs. Never try to
repair the unit yourself because it is dangerous to do so.
Cautions;
• Do not use the unit if it malfunctions or
something is wrong.
• Do not use the unit in abnormal conditions,
for example, without sound, or if it emits
smoke or a foul smell, which can cause
ignition or electric shock. Immediately stop
using the unit and catt the store where you
purchased it.
Troubleshooting Tips
■ Common
(
Trouble
)
No power
Noise
No sound
______________________
_ J
Audio sound is out
put but the display
shows demonstration
message.
Cause / Step
3
Car’s engine switch is not on.
^ Turn your car's ignition switch to ACC or ON.
Cables are not correctly connected.
*4 Connect cables correctly.
►
Battery cable is not correctly connected.
^ Connect the battery cable to tbe terminal that is always live.
Accessory cable is not correctly connected.
^ Connect the accessory cable to your car's ACC source.
Grounding wire is not correctly connected.
^ Connect the grounding wire to a metal part of your car
Fuse is burnt.
^ Call the store where you purchased the unit, or your nearest Servicenter
(see the attached sheet) and ask for fuse replacement.
[►
►
[►
Mute is set to ON.
Set it to OFF.
Cables are not correctly connected.
^ Connect cables correctly.
Condensation (dew)
^ Wait for a while before use.
/■
A mobile phone is used near the unit.
>
^ Keep the mobile phone away from the unit.
V---------------------------------------------- -------- -------__________________/
Demonstration mode is ON.
Press [DISP] (DISPLAY) to cancel demonstration mode.
32
CQ-DP171U