DVR systems DVRxx04HF-U Series - Manual (Page 94)

84
z Protocol: Select corresponding PTZ protocol such as PELCOD.
z Address: input corresponding PTZ address.
z Baud rate: Select baud rate.
z Data bit: Select data bit.
z Stop bit: Select stop bit.
z Parity: There are three choices: none/odd/even.
After completed all the setups please click save button, system goes back to the previous
menu.
For detailed setup, please refer to chapter 4.9 preset/patrol/pattern/scan.
Figure 5-24
5.3.9 Display
Display setup interface is shown as below. See Figure 5-25.
z Transparency: Here is for you to adjust transparency. The value ranges from 128 to
255.
z Channel name: Here is for you to modify channel name. System max support 25-digit
(The value may vary due to different series). Please note all your modification here
only applies to DVR local end. You need to open web or client end to refresh channel
name.
z Time display: You can select to display time or not when system is playback.
z Channel display: You can select to channel name or not when system is playback.
z Resolution: There are four options: 1280×1024(default),1280Ч720,1024Ч768,800
Ч 600. Please note the system needs to reboot to activate current setup.
z Enable tour: Activate tour function.
z Interval: System supports 1/4/8/9/16-window tour. Input proper interval value here.
The value ranges from 5-120 seconds. In tour process, you can use mouse or click
Shift to turn on window switch function. Stands for opening switch function,
stands for closing switch function.
z Monitor tour type: System support 1/8-window tour.
z Alarm tour type: System support 1/8-window tour.