DVR systems DVRxx04HF-U Series - Manual (Page 140)

130
For 960H series only
Figure 7-32
Please refer to the following sheet for detailed information.
Parameter Function
Network Mode Includes multiple access, fault tolerance, and load balancing
Default Network
Card Please select eth0/eth1/bond0(optional) after enable
multiple access function
Ethernet Please select eth0/eth1 (optional).after enable multiple
access function.
Note: The 960H series support the above three configurations and supports
functions as multiple access, fault-tolerance and load balancing.
Ethernet Please select the network card first.
DHCP Dynamically get IP address. You can get the device IP from
the DHCP server if you enabled this function.
TCP Port Default value is 37777.
HTTP Port Default value is 80.
UDP Port Default value is 37778.
RTSP Port Default value is 554.
Max Connection Network user max amount. The value ranges from 0 to 20.
O means there is no user can access current device.
Remote
Host Multiple
cast
group
—
Set MULCAST address and port.
— Enable MULCAST function.