DVR systems DVRxx04HF-U Series - Manual (Page 83)

73
z Function: There are various devices for you to select. Console is for you to use the
COM or mini-end software to upgrade or debug the program. The control keyboard is
for you to control the device via the special keyboard. Transparent COM (adapter) is
to connect to the PC to transfer data directly. Protocol COM is for card overlay
function. Network keyboard is for you to use the special keyboard to control the
device. PTZ matrix is to connect to the peripheral matrix control.
z Baud rate: You can select proper baud rate.
z Data bit: You can select proper data bit. The value ranges from 5 to 8.
z Stop bit: There are three values: 1/1.5/2.
z Parity: there are five choices: none/odd/even/space mark.
System default setup is:
z
Function: Console
z Baud rate:115200
z Data bit:8
z Stop bit:1
z Parity: None
After completing all the setups please click save button, system goes back to the previous
menu.
Figure 5-8
5.3.5 Network
Here is for you to input network information. See Figure 5-9.
z
Network Mode : Includes multiple access, fault tolerance, and load balancing
z Default Network Card: Please select eth0/eth1/bond0(optional) after enable
multiple-access function
z Main Network Card: Please select eth0/eth1 (optional).after enable multiple
access function.
Note: The 960H series support the above three configurations and supports
functions as multiple-access, fault-tolerance and load balancing.
z IP address: Here you can input IP address.
z DHCP: It is to auto search IP. When enable DHCP function, you can not modify
IP/Subnet mask /Gateway. These values are from DHCP function. If you have not
enabled DHCP function, IP/Subnet mask/Gateway display as zero. You need to