Daiwa SEABORG-300FB - Manual (Page 4)

2
Power source
How to connect the reel to the power source
About the power source
Battery indicator
1. Attach the cord clips to the battery. Red covered clip is the plus
(+), and the black covered clip is the minus (-).
2.
Insert the connector into the reel. After this, the display
appears as below.
By taking the appropriate steps, the indication will
change as shown below and the data will be set.
This reel is made to accept DC 12 Volt power only. Power sources
providing other than this cannot be used.
The power provided by a boat can be unstable, causing the reel to
stop unintentionally. Please use a battery made specifically for
fishing reels, such as our lithium battery.
With power on, digits of the inverse counter (counter in the lower
area) will blink if voltage gets below DC 9 V.
If the display shows this when the motor is not running, then
battery voltage is likely to be low. In this case, replace the battery
with a recharged one.
Attention
1. When changing batteries, the display’s backup memory stays active for about 15 minutes
after the old battery is disconnected. Thus the above display startup sequence does not
need to replay when the new battery is connected within the 15 minute time frame.
Attention
Make sure of the following before departure.
1. Recharge the battery before your fishing trip. Over time, a battery can naturally discharge.
2. Confirm the boat can provide the proper power source (i.e. voltage, connector shape etc).
3. Corroded connections can prevent the flow of electric current. Remove any corrosion or
dirt from the connectors.
This figure shows the
voltage is 8.5 V
Black
Red
Match slot
with key
0.5 sec
All the articles light An indication change Set completion