Daiwa SEABORG-300FB - Manual (Page 14)

12
Attention
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF position, and wind manually when nearing the
end of the line.
OFF
9
10. Press RESET BUTTON for 2 seconds, until the display shows
300 . (300 is the default setting)
9. Pull the lever back to the OFF position, after winding.
11.
Move the power lever to adjust line length reading (in the
figure on right, length is adjusted to 250m).
12.
Press RESET BUTTON for 2 seconds and a beep will be
heard. The display should return to 0.0 , completing the setting
procedure.
If “ Err ” appears on the display, go back to STEP 5 and
re-enter the data again.
Line data input
(When line length is known)
10
OFF
Power lever
Do not reel in the end of the line
12
P1 Inputting the line length
OFF MAX
UP DOWN
11