Daiwa SEABORG-300FB - Manual (Page 24)

22
Line feeding function
The line feeding function lets our line with the motor assisting the spool.
- The line feeding mechanism begins to work at a depth of 2.5 m
below the pre-set auto stop depth.
- Speed of the line going out is adjusted with 32 speed levels
ranging between 0 and Hi. It is adjusted in the line feeding
mode.
3. Press the MODE BUTTON to show 0.0 (depth counter) to
complete.
(adjustment of
line furnishing)
(the figure corresponds
to the case of setting to 5)
Functional setting operation
(4. Line feeding function)
OFF
3
1
2
- Once the line feeding stops due to backlash or other reasons,
the feeding will not start again.
1. Simultaneously hold down the INVERSE COUNTER BUTTON
and the MODE (JIG/PICKUP) BUTTON to display the setting
mode. Then, press the MODE (JIG/PICKUP) BUTTON to
display the “line feeding output adjustment” mode.
2.
Set the speed level with the power lever.
Default setting is zero (OFF).
The will blinks.
Attention
If the clutch is set ON during line feeding(the motor in operation), excessive line is wound
in.
1.The rig may be too light or the line feeding output was set too high causing the line to
overrun.
2.Reduce line feeding output and setting the line feeding to the OFF position.