Daiwa SEABORG-300FB - Manual (Page 17)

15
Line data input
(Inputting the drawer)
This method is applied to data re-input which is to be made after the main line is wound up. This
method requires a main line of 100m or longer specific length.
1. Turn on the electricity.
or
2
3
P0 will be blinking.
The display will change to the pickup mode 2 seconds after the
buttons are pressed, but keep pressing the buttons, and the
display will change to the line setting mode.
MODE
(JIG/PICKUP)
BUTTON
MODE
(JIG/PICKUP)
BUTTON
MODE
(JIG/PICKUP)
BUTTON
P3 Inputting the drawer
3.
Press the MODE (JIG/PICKUP) BUTTON and set the mode to
backing line 2.
P3 will be blinking.
4.
Paying attention to the lineʼs color coding, pull 50 m of line off of
the spool.
2. While “ 0.0 ” is shown in the display, press INVERSE COUNTER
BUTTON and JIG/PICKUP BUTTON simultaneously and hold
for 6 seconds, until the display shows P0 on left area of the
display.