Daiwa SEABORG-300FB - Manual (Page 34)

32
Various alarms
Many kinds of information are indicated by audible alarms.
Display light
Backlighting of the display provides easy reading for early morning or night fishing.
Notification message of belt replacement timing
Power lever alarm
- Placing the Power lever at MAX or OFF positions evokes an alarm.
Auto stop alarm
- While winding up, starting 6 m below the auto stop depth, an alarm beeps at two meter intervals. Upon reaching
the auto stop depth, a long alarm sounds.
Range memory alert
- While lowering your rig back into the strike zone, starting 6 m above the memorized strike depth, an alarm
sounds at two m intervals with a long alarm sounding once the target depth is reached.
(This range memory alarm does not sound unless line has been wound more than 6 m above the memorized
depth.)
Switch alarm
- Each time a button is pressed, a confirming beep is sounded.
Excessive voltage alarm
- Should you attach a power source with a voltage higher than the acceptable level, a continuous alarm will
sound. DO NOT operate the reel. Disconnect the power source. Connect a power source with the proper
voltage.
Timer alarm
- Chumming timer winding is indicated by an alarm.
-When recommended belt replacement timing draws near, an alarm sounds and a
notification message shown with the figure appears when the reel power is turned
on. If you see this mark, please request maintenance through your sales agent.
(with charge)
The default setting is ON.
-When the alarm is OFF, the alarm will not sound even when the button is
pressed or the power lever is tilted.
Open the Mode setting and display the alarm ON/OFF mode.
Set the alarm to OFF with the power lever.
-Pressing the MODE BUTTON brings back to the water depth mode, by
which the setting is completed.
-The alarm sound for button operation and power lever ON/OFF setting
can be set to OFF.
Backlighting of the display provides easy reading for early morning
or night fishing.
- As long as the reel is connected to a power source, the display
backlight is on.
(The reading change can be set to OFF in the
mode setting.)
Functional setting operation
(11.Useful functions)
ON/OFF selection of alarm
The alarm indication (beep)can be turned off in the Mode setting.