Daiwa SEABORG-300FB - Manual (Page 23)

21
Functional setting operation
(3. Auto stop function)
Auto stop
Auto stop automatically brings your terminal rig to the surface, stopping consistently at your
pre-set depth preference. It eliminates the need to constantly monitor depth as it comes up.
- The auto stop function assists when winding with the power lever, jigging, or winding with the chumming timer.
- After the rig is ready, reset the depth counter to zero by pressing the RESET BUTTON .
(water surface zero setting) (After this, appears on the display)
- Without pressing the RESET BUTTON , winding stops at a depth of 5 m.
- If you have pressed the RESET BUTTON , the alarm sounds at 2m increments above the depth of 8 m, and
winding stops at 2 m.
- When auto stop depth is set, the alarm sounds every 2 m above the depth of 6 m, and winding stops at the set depth.
- After auto stop stops winding, the power lever can be used up to 0.0 m. However, above 0.0 m, motor winding
such as, power lever, cannot be employed until the RESET BUTTON is pressed.
- Depending upon the rocking of the boat or sinker weight, auto stop depth can overrun slightly. Should this
happen, increase the depth of the auto stop.
- Fishing line load may vary when working depths of 100m or more. This may cause the stop position to change,
which may result in serious rod damage. Allow for greater margin when setting the AUTO STOP position when
fishing deeper depths.
Set the depth to 0 and throw in your rig.