Daiwa SEABORG-300FB - Manual (Page 37)

35
Trouble shooting
19
6
2
2
2
2
2
19
20,21
17,18
19
22
11-16
11-16
27-29
Symptom Possible causes To do
Ref.
page
Motor does not
respond to the
power lever
Counter display
does not appear.
The reel jigs on
its own.
Auto stop
function does
not work
Did not pull the lever to OFF
position.
Unstable power source
Incorrect battery connection
Low power voltage
Did not press RESET BUTTON
at surface
Error for sinker weight or
rocking of the boat
Line is elongated.
The counter displays m.
Battery charge is low.
Cord worn or corroded
It is a normal function to avoid over
winding. Press RESET BUTTON to
continue winding.
Pull the lever to OFF and then move
forward again to start winding.
Use another power source, such as
electric reel specific batteries.
Recharge the battery.
Replace the cord.
Replace with a recharged battery.
Press RESET BUTTON to reset depth
to zero with rig at the surface.
Adjust settings of auto stop function.
Reset the depth counter at the surface.
Connect correctly.
Contact your dealer if the reel does not function properly despite the above details being confirmed, in the event of
other problems arising, and to order parts.
Jigging function
does not
respond
There are
counter errors.
Pickup does not
respond.
Power lever is at OFF
Speed setting is at zero
Push the lever forward.
Re-enter line data.
Re-enter line data.
Press MODE BUTTON to select winding
speed setting.
While fishing the line was
wound in without power source.
The
RESET BUTTON was
held down while the line was
fed.
The rig may be too light or the
line feeding output was set too
high causing the line to
overrun.
Reduce line feeding output and setting
the line feeding to the OFF position.
If the clutch is set
ON during line
feeding, excessive
line is wound in.