Daiwa MARINEPOWER-3000 - Manual (Page 9)

7
Names and functions of each part
weak strong
Power lever 1
Drag lever 2
Clicker lever 4
Drag pre-set knob 3
Level wind 5
-You can freely adjust winding power, or winding speed, from MIN to MAX
by using the lever.
-Tilting the lever forward adds power and speeds up the winding.
Pulling the lever back reduces the power and slows down the winding.
-Check that the power lever is at the MIN position. If not, turn the lever
back to the MIN position before initial winding. (An alarm sound will be
heard at the MIN position.)
-Use the power lever to adjust numerical values of the various functions.
-Turn the power lever to MAX to increase the value.
-Turn the power lever to MIN to decrease the value.
- Pulling the lever back decreases the dragging force exerted on the
spool, setting the spool free.
- Tilting the lever forward increases the dragging force on the spool.
- The dragging force can be adjusted from the maximum to the minimum
simply by moving the lever.
-Turn the drag lever to the FREE position. Then adjust the drag reset
knob until proper drag pressure with a smooth freespool is achieved.
-Tightening the drag pre-set knob will increase the drag power.
-Be careful not to overtighten the drag pre-set knob. Too much pressure
will affect the reel's freespool.
-With the drag pre-set knob, it is easy to fine tune the drag pressure while
fishing.
-When the clicker lever is set to the On position, a clicking sound will be
heard when the spool is turned.
-The levelwind evenly distributes the line onto the spool during winding.
-Under some special circumstances, the line may fail to wind evenly
because of the clearance between the levelwind and the line.
-If the end of the line is wound onto the spool, the positions of the level-
wind and line may become misaligned. This will generate resistance as
the line coming of the spool will work against the levelwind, which will
affect the freespool and the rig's ability to sink smoothly.