Daiwa MARINEPOWER-3000 - Manual (Page 13)

11
Attention
1. Do not wind the end of the line onto the
spool because it causes incorrect length
calculation. Move the power lever to
MIN position, and wind manually when
nearing the end of the line.
Attention
7
8
9
10
8.
Press RESET BUTTON for 2 seconds, until the display shows
1400 . (1400 is the default setting)
7.
Pull the lever back to the OFF position, after winding.
9.
Enter the line length with the power lever. (in the figure on the
right, line length is 1000 m).
10. Press RESET BUTTON for 2 seconds and a beep will be
heard. The display should return to 0.0 , completing the setting
procedure.
If “ Err ” appears on the display, you must use the MODE SET
BUTTON to re-enter the data.
Do not reel in the
end of the line
Line data input
(When line length is known)
Return
Up
DOWN
Main line
Power lever
1.Do not wind the line end onto the spool. Otherwise, misalignment may occur between
the levelwind and the line, which can prevent the rig from smoothly going down to the
water.