Daiwa MARINEPOWER-3000 - Manual (Page 3)

DO NOT allow the end of the line to be wound onto the spool. This may
cause the synchronization with the levelwind to be lost. This condition
can damage the levelwind due to the reel's high power output. Should
this happen, the line needs to be removed from the spool and rewound.
Caution
Precautions
W
arning
Attention
1. Be careful to keep fingers clear of the levelwind mechanism. It can pinch your fingers
and cause injuries.
2.If the reel is mounted onto the rod without the rod clamp, there is a chance that the reel
may fall off the rod. Be sure to securely mount the reel to the rod using the rod clamp
before putting the reel to use.
1. If your sinker or lure is caught on the bottom, cut your line rather than jerk the rod to
free it.
2. After fishing, rinse and dry the reel thoroughly. Store in a dry place.
3. Handle the reel with care. Dropping it may cause damage.
4. Do not touch the line while reel is running. It could cut your skin.
5. Use this reel for fishing purposes only.
6. Be careful not to get reel grease on your clothing.
7. Do not use metal wire for the main line.
8. Sharp impacts due to inadvertent drop or other reasons may cause reel body
breakage, damage to the inner electronic components, and cracks or short circuit of the
board, resulting in functional disability.
1. Do not disassemble the reel.
1. Do not touch moving parts while the reel is operating or it may cause injury.
1. When you use a power source other than the battery or the power source provided by
the boat, be sure it is of the proper voltage. Excess voltage will harm the reel and may
generate enough heat to burn your hands.
2. Do not use badly rusted cord to prevent electrical heat.
1
Do not reel in the end of the line
Do not reel in the
end of the line
Main line
Snap