Daiwa MARINEPOWER-3000 - Manual (Page 16)

14
2. Place the rod into the rod holder in the position it will normally
rest while fishing. Lower the terminal rig to the water's surface
and press the RESET BUTTON .
An indicator 0.0 will appear.
Before you begin fishing
Drag lever
2
1
Attention
1. When new line is wound up, or when line has been pulled under heavy tension, line
stretch may cause a gap in the depth reading at the surface. Simply reset the surface
setting with the reset button.
2.Should your line break, revise data as follows.At depths greater than 10 m,
5-second-pressing is employed accidental pressing of the button.
Surface depth setting
Before you begin fishing, make sure the counter is set to zero at the waterʼs surface. It allows you to
correctly locate the rig at a desired depth.
1. Connect the power cord. Then turn the drag lever to the FREE
position, put the line through all the guides, and prepare your
terminal rig.