Daiwa MARINEPOWER-3000 - Manual (Page 14)

12
Line data input
(With backing line)
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 200 m.
1 Levelwind Guide
Main line
Pin
Spool
Power lever
1.
Run the backing line through the levelwind guide and tie it onto
the spool. The levelwind threader makes this process easier.
Make sure to tie the line onto the pin found on the spool to
avoid the line slipping.
5
6
7
Display revision indicator input display
Backing input display
2. Move the power lever to the MIN position.
3. Connect the power cord clips to the power source12VDC).
4. Attach the power cord connector to the reel.
5. Press the INVERSE COUNTER BUTTON for 5 seconds, until
the display shows 0.0 .
7.
Wind the remaining backing line, keeping line tension at the
suggested level.
While winding the line with the power lever positioned at MAX,
keep line tension (indicated at the lower left of the display)
between 8 and 9.
If the line will not wind with the power lever positioned at MAX,
wind the line with a little lower tension.
Keep pressing the INVERSE COUNTER BUTTON even after the
display is switched to the display revision indicator.
6. When the display is switched to the input screen, press the
INVERSE COUNTER button again to switch the display to the
backing line winding screen.
2 Return