Daiwa MARINEPOWER-3000 - Manual (Page 17)

15
Functional setting operation
(1.Auto stop function)
Auto stop
function 10m
Auto stop
function 30m
-After the Auto Stop function stops widing, the power lever can be
used only up to when the display shows 0.0 . From 0.0 , the
power lever will seize to operate until the RESET BUTTON is
pressed. This mechanism will prevent the rig from cranking
through the guides caused by erroneous operation.
The reel is equipped with the Auto Stop Setting function, which automatically stops motor winding at a certain
point, to prevent accidents such as breaking of a rod tip caused by a wound rig.
-Set the Auto Stop Setting to stop winding at 10 m. depth position
when fishing less than 400 m.
-Set the Auto Stop Setting to stop winding at 30 m. depth position
when fishing more than 400 m.
In case that the current winding tension largely differs from
tension during the previous winding, winding may fail to stop at
a correct position. In such a case, set the surface depth setting
again.
See page 14 for surface depth setting.
Less than 400 m
Depth of 400 m
400 m or deeper