Daiwa MARINEPOWER-3000 - Manual (Page 12)

10
Line data input
(When line length is known)
This is an input method where the display is switched to the input screen first, and then the length of
wound line is set.
1. Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
2.
Move the power lever to the MIN position.
3. Connect the clip to the power source (12V DC).
4. Attach the cord connector to the reel.
See in page 2 for the connection method.
Levelwind Guide
Main line
Spool
Pin
Power lever
1
2
5
6
Display revision indicator
input display
Return
5. Press the INVERSE COUNTER BUTTON for 5 seconds, when
the display will show 0.0 .
6. Push the power lever forward to maximum and wind the line to
its end.
As the power lever is moved forward, a tension indicator is
appear.
Keep pressing the INVERSE COUNTER BUTTON even after the
display is switched to the display revision indicator.
If the line will not wind with the power lever positioned at MAX,
wind the line with a little lower tension.
Tension indicatar