Daiwa MARINEPOWER-3000 - Manual (Page 4)

2
Power source
How to connect the reel to the power source
1. Attach the cord clips to the battery. Red covered clip is the plus
(+), and the black covered clip is the minus (-).
2.
Insert the connector into the reel. After this, the display
appears as below.
By taking the appropriate steps, the indication will change as
shown below and the data will be set.
0.5 sec
Attention
1. When changing batteries, the display's backup memory stays active for approximately
15 minutes after the exhausted battery is disconnected. Thus the display start-up
sequence does not need to be reset when the new battery is connected within the 15
minute time frame.
Match slot with key
All the articles light An indication change Set completion
Connector
Breaker System
- When an excessive load is applied to the motor, the breaker will start to work to protect the motor. The
alarm will keep sounding while the breaker is in operation. (The breaker will stay in operation up to 30
seconds and will reset automatically.)
Memory Backup System
- When the power cord suddenly falls off, the counter data will be stores for a certain period of time. Simply
reconnect the power cord and coninue fishing without any additional setting.
- Even if the power is temporarily cut off during fishing, such as when the power cord falls off, the counter
panel data shown at the time of disconnection will remain in an IC chip for at least 15 minutes. Therefore,
the only thing needed is to reconnect the power cord. The counter panel display will be restored and you
can resume fishing.
Note: If the battery goes flat while the motor is running, the motor will not start running even after the power
cord is reconnected. This is to ensure safety.
Black
Cord
Battery
Red