Webs-retro-mt installation instructions – Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers User Manual
Page 4

WEBS-RETRO-MT Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 4 of 4
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
5) Repeat steps 3 and 4 to install the second amplifier with mounting bracket to a second anchor bolt of
the ETP-MT Tower.
NOTE: Although the amplifier mounting brackets have rain shields, it is the installer's obligation to ensure that
proper drip loops are created with the help of the extension wire, in order to prevent condensation from damaging
the amplifiers.
6) Connect the power supply for the paging amplifier, blue light/strobe and any optional devices (e.g.
VOIP-CM-1.)
7) Use the PAGE VOL screwdriver-adjustable control on the paging amplifier to adjust the volume of the
page output. Rotate the control clockwise to increase the volume and counterclockwise to decrease
the volume.
8) Reattach the rear access panel.
Figure 3. Fully assembled WEBS-RETRO-MT showing Retrofit Tower Top and Paging Amplifier kit (wiring not shown)