WEATHER GUARD Model 2521 EZ-GLIDE® Accessory Cross Member, Full-Size, GM - Manual (Page 3)

3
STEP 2 (2 places)
If you are placing this Cross-Member on
a vehicle with an existing EZ-GLIDE™
Rotation System, you will not use the
End Stop (A) on the rotation side.
Attach End Stop (A) to Cross-Member (B)
with 5/16-18 x 2-3/4" Fasteners.
(B)
(A)
(2) 5/16-18 x 2-3/4"
Hex Hd. Bolt
(4) 5/16-18 Flat
Washer
(2) 5/16-18 Nylon
Lock Nut
STEP 3 (2 places)
Attach Mounting Base with Gusset and Clamp
(A) to Cross-Member (B) with 5/16-18 x 2-3/4"
Fasteners.
(A)
(2) 5/16-18 x 2-3/4"
Hex Hd. Bolt
(4) 5/16-18 Flat
Washer
(2) 5/16-18 Nylon
Lock Nut
(B)
NOTE: To allow for final
fit-up, do not tighten
these fasteners at this
time.
5/16-18 x 1" Phillips
Flat Hd. Screw
STEP 1 (2 places)
Attach Mounting Base (A) to Gusset (B) and Clamp (C) with
fastener shown. Tighten only the 5/16-18 x 1" Phillips Screw,
leave all other fasteners loose for easer mounting on vehicle.
(A)
(B)
5/16-18 Flat
Washer
(2) 5/16-18
Nylon Lock Nut
(C)
1/4-20 x 2"
Bent Bolt
(2) 1/4-20
Flat Washer
1/4-20 Nylon
Lock Nut
5/16-18 x 1-1/2" Carr. Bolt for Model 2511 (Ford)
5/16-18 x 2" Carr. Bolt for Model 2521 (GM)