WEATHER GUARD Model 250 Sliding Ladder Rack - Manual (Page 6)

6
Before loading ladder into rack:
1. WEATHER GUARD recommends the Model 250 sliding ladder rack be installed in service or delivery
vans equipped with a bulk head. A bulkhead divider between cargo and driver/passenger compartment
reduces the likelihood material will come forward and cause personal injury during a vehicle accident.
2. The sliding ladder rack is designed to be loaded from the back of a cargo van or pickup truck with a
metal cap.
3. Before loading a ladder, make sure the elastic cords and the stop bracket are installed and positioned
correctly. See Installation steps 7 & 8 on pages 3 & 4. If a different size ladder is to be loaded then the stop
bracket and the elastic cords must be adjusted or the ladder will fall from the rack.
4. Inspect the parts of the ladder rack before using. If any part is broken, bent or damaged in any way do
not use rack. See Maintenance section for replacement parts.
Loading ladder into rack:
1. Ensure the ladder is clean and dry.
2. Open van’s rear doors or truck hatch to access rack.
3. Pull on elastic cords to move the sliding catch toward the rear.
4. Position the ladder with the step side down (non-step side up).
5. Lift the top of the ladder and place it in the front cradle. See Figure 7.
USAGE INSTRUCTIONS
WARNING
• Inspect the sliding ladder rack before each use. Do not use rack if it is damaged or deteriorated in any way.
• Do not place shorter ladder in rack adjusted for longer ladder. Always adjust stop plate and elastic cords for
length of ladder being loaded.
• Incorrect loading or unloading of the sliding ladder rack could allow ladder to fall and cause serious personal
injury or property damage.
• Never operate the rack with persons seated below or near the rack and ladder.
• Be careful when loading ladder into the sliding ladder rack if standing on slick or icy ground.
• Do not load or unload ladder when vehicle is moving.
Optional Installation
Step 10: SIDE MOUNTING INSTALLATION INSTRUCTIONS (ONLY)
Install side catch brackets to adjustable mount with two 1/4-20 x 7/8” carriage bolts, 1/4” flat washers, and
1/4-20 nylon lock nuts as shown in Figure 6. Install rail assembly to side of enclosed trailer.
Figure 5
Figure 6
Step 9: RAIL LUBRICATION
Apply a generous amount of lithium grease to the inside of the rail allowing for smooth travel of the sliding
front cradle.