WEATHER GUARD Model 96515-3-01 Window Bulkhead, Compact, RAM CV - Manual (Page 3)

24-0340 3 Part No. 24-0340 REV. A
STEP 4: Place header panel into van and mark location on headliner of clearance slot cut
(should be along ridge in headliner). Remove header panel and cut clearance slot. See
Figure 3.
STEP 4: Mount header panel to bulkhead using 1/4-20 x 3/4" bolts, washer, and lock nut and
tighten. Mount header panel to van using 1/4-14 self-tapping screws. See Figure 4.
Before installing blind fasteners, verify the
location of you gas tank, fuel lines and
electrical cables so you don’t accidentally
damage something important.
Place a drop of oil on the black oxide bolt
before assembling as shown on right.
Place the Blind Fastener in the hole and use
a 7/16" wrench to tighten black hex bolt until
the Blind Fastener is fully seated.
When setting black hex bolt, it will start out
hard. As the Blind Fastener
“bulbs-out” it will
get easier to turn until it bottoms out and
“sets”.
Make sure the Blind Fastener and
Installation Tool do not turn during
installation.
INSTALLAUCTIONS FOR BLIND
FASTE
7/ 16” Wrench
(or 7/ 16” Socket)
Black Oxide Bolt
Flat Washer 9/ 16” Wrench
Installation Tool
Blind Fastener
Figure 2 Figure 3
Cut along edge of headliner.
INSTRUCTIONS FOR INSTALLING BLIND FASTENERS