Warning – WEATHER GUARD Model 3400 BED RAT® Sliding Platform, 90 in x 44-3/4 in x 4-3/4 in User Manual
Page 6
WEATHER GUARD® products are protected by one or more of the following trademarks:
U.S. - 842268, 1661625, 1663369, 1840451, 1901674, 2228051, 2362167; Canada - 282725; U.K. - 1400720; N.Z. - 296049 other trademarks pending.
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
WARNING
Prior to drilling, so as not to cut
or puncture fuel tanks, fuel
lines, brake lines, electrical
wires, etc., check under vehicle
for locations.
Black
Oxide
Bolt
Flat
Washer
9/16
Wrench
Installation
Tool
Blind
Fastener
INSTALLATION PROCEDURE USING BLIND FASTENERS
Place a drop of oil on the
black oxide bolt before
assembling as shown on
right. Place the Blind Fas-
tener in the hole and use
a 1/2 or 7/16 wrench to
tighten black hex bolt until
the blind fastener is fully
seated. When setting
black hex bolt, it will start
out hard. As the Blind
Fastener bulbs out it will
get easier, until it bottoms
out or sets. Make sure the
Blind Fastener and Instal-
lation Tool do not turn dur-
ing installation.
Knaack LLC
ATTN: Warranty Claims
420 E. Terra Cotta Avenue
Crystal Lake, IL 60014
If you have any questions, please call toll free at 1-800-456-7865.
©2013 Knaack LLC
Part No. 24-3201 REV. H ECN 5282 03/13