WEATHER GUARD Model 3400 BED RAT® Sliding Platform, 90 in x 44-3/4 in x 4-3/4 in - Manual (Page 3)

3
3/8" Hole
1/2" Hole
2" For most Pickups
and all Vans
Inside edge of
tailgate or van
doors
Figure 2. Base Assembly marking/drilling (Model 3400 shown)
No Holes
Required
ASSEMBLY INSTRUCTIONS for
Models • 3200 • 3300 • 3400
(see back page for Model 3100)
NOTE: To prevent rust from occurring, touch-up any
drilled holes.
1. Place the Base Assembly centered in the vehicle. See
Figure 1. for correct location. Close the tailgate or doors to
make sure the unit is properly placed. If installing a Model
3100 out a van side door(s), make sure to take into account
the door opening width. If installing a bulkhead, this should
be done first.
3. Remove the Base Assembly and re-drill the floor holes
using a 1/2" drill bit.
WARNING
All floor mounting bolts near the gas tank area
should be installed from the underside of the ve-
hicle, to guard against the gas tank being punc-
tured in the event of a collision. This would mean
not using Blind Fastener in this area. Holes drilled
in this area should be 3/8".
2. Mark hole locations on the mounting bars, centering the
holes on the bars and on the top portion of the floor ribs if
possible. If it is not possible, four Spacers have been pro-
vided to fill the space between the mounting bars and the
lower part of the floor ribs. NOTE: Twelve holes are required
for Models 3300 & 3400, eight holes for Model 3200 (see
Figure 2. for mounting holes) and four for Model 3100 (see
Figure 3.). Drill through the mounting bar and the floor at
one rear location, and insert a 5/16-18 x 1-1/2" Hex Hd. Bolt
into the hole. Drill one front mounting bar location, and insert
a bolt. Drill the rest of the mounting bar/floor holes.
CAUTION
To keep debris out of your eyes when checking
the underside of the vehicle, or when drilling,
always wear protective eyewear.
WARNING
Prior to drilling, so as not to cut or puncture fuel
tanks, fuel lines, brake lines, electrical lines, etc.,
check under vehicle for locations.