WEATHER GUARD Model 156-3-01 Saddle Box, Steel, Compact Standard, 6.4 cu ft - Manual (Page 2)

2
Note:
• If your pickup is with a plastic drop-in bed liner, it may
need to be drilled, trimmed, or cut for proper installation of
truck box.
• Truck box cover may not properly latch until box is fully bolt-
ed to truck bed (4) places.
• Because truck bed rations vary, (6) mounting slots
have been provided, to ensure the use of (4) mounting
clamps.
• Periodically check tightness of mounting clamps to insure
proper attachment.
• Use touch-up paint on any drill holes to prevent oxidation.
• Install boxes with vehicle parked on level ground.
Step 1: LOCATE BOX IN TRUCK BED
• Place rubber mounting pads on bed rails.
• Place box into position on top of mounting pads.
• Use ruler to ensure box is centered in truck bed, and
that cover opens fully without interference.
Step 2: ATTACHED BOX TO TRUCK BED
• Attach mounting clamp, bolts and washers as shown in
Figure 2.
• Start with slot at drivers side front and work clock-wise until
all four clamps have been installed.
Note: Mounting clamp bolt may be di to turn due to the
“lock nut” feature. Apply a small amount of grease to
bolt threads prior to installation to ease assembly.
INSTALLATION INSTRUCTIONS
Pad
Pad
Bed Lip
Mounting Pad
End Panel Slot
Mounting Clamp
Fender Washer
Figure 2
Figure 1
Check clearance
with cover open
LOCK SYSTEM
The WEATHER GUARD® Extreme Protection Lock is designed to provide maximum security, while providing ease ™
of use and years of reliable service. When in the locked mode, the button remains retracted in a tamper-resistant
position. When the button is pressed in the unlock mode, the latches are activated and the cover opens.
FEATURE OPERATION
LOCK
Turn the key counterclockwise to the
locked position as indicated on the
lock bezel. When the button is now
pressed, it will stay in the retracted
or tamper-resistant position until
unlocked.
UNLOCK
Turn the key clockwise to the un-
locked position as indicated on the
lock bezel. Button will pop out and is
now ready to release the latches
when pressed.