Satellite Freedom 2 (old) - Manual (Page 3)

INTRODUCTION
Satellite portable restrooms must be assembled according to approved assembly procedures. Avoid variations in
assembly procedures which could adversely affect product life and warranty.
TOOLS:
• 3/8” Hex Socket Driver • Pop Rivet Gun
• #10 or 3/16”, and ¼” Drill Bit • Phillips and Flat Screwdrivers
• Drill
All references to left, right,
front and rear correspond to
this illustration.
HELPFUL HINTS:
• Keep panels out of direct sunlight.
• Don’t open up all of your kit boxes. Open up only enough kit boxes to assemble the number of toilets you are
currently working on. KEEP PARTS ORGANIZED.
• It is very important to keep all panels positioned correctly when transfer drilling holes.
1. INSTALL ALL THE FLOOR ANGLES AND ANGLE BRACKETS TO THE FLOOR
Rivet the angles to the floor using #610 stainless rivets and back-up washers.
PN 14579/REV, X
page 3