beautypg.com

Satellite MX2 Wet Lift User Manual

Instructions tufway/mx2 high rise hanger

background image

PN 15208 REV D Page 1 11-14-11

INSTRUCTIONS TUFWAY/MX2 HIGH RISE HANGER

INTRODUCTION: Satellite portable restrooms and accessories must be assembled according to approved assembly procedures.

Variations in assembly could adversely affect product life and warranty.

NOTE: Install only on Satellite Tufway® or Maxim 2000® with Satellite® solid recycled plastic base.

HARDWARE

TOOLS
*Drill Elec/Cordless *3/4” Drill Bit *3/8 Socket Driver Bit *Adjustable Wrench *Pliers

1.

Tip the unit over so that the door is facing upward.

2.

Insert the skid straps between the 4x4's and up against the 2x4 and fasten with #14 x 1-1/2 screws. (3) screws for each

skid strap. (See Figure A)

3.

Using the hole in the skid strap as a guide. Drill a 3/4” hole through runner. Repeat on (3) remaining holes. (See Figure

B)

4.

Insert the threaded ends of sling into the 3/4” holes in the 4x4 on both sides.

5.

Place the clip over the sling just above where it goes through the 4x4. (See Figure C)

6.

Fasten clip down with (2) #14 x 1½ screws. Repeat on (3) remaining slings.