Satellite MX3 Turbo Foot Flush User Manual
Instructions maxim 3000 ® turbo flush installation, Step#1 step#2

17823 REV J
1
2-1-12
Instructions
Maxim 3000
® Turbo Flush Installation
INTRODUCTION
Satellite portable restrooms and accessories must be assembled according to approved assembly procedures.
Avoid variations in assembly procedures, which could adversely affect product life and warranty.
HARDWARE:
Luxury
Flush & Wash
F
L
U
S H
Tools:
• DRILL
ELEC/CORDLESS
• HOLE SAW 5.50"[140mm]
• RECIPROCATING
SAW
• STANDARD
SCREWDRIVER
• HOLE SAW 4.50"[115mm]
• PLIERS
• PHILLIPS SCREWDRIVER BIT
• HOLE SAW 2.00"[50mm]
• #10 DRILL BIT
• 5/16"[8MM] NUT DRIVER BIT
• HOLE SAW 1-1/2"[38mm]
• RIVET
GUN
• 5/32"[4mm] HEX HEAD WRENCH
• HOLE SAW 1-1/8"[29mm]
• 7/16" DRILL BIT
Prepare Base Assembly. (If pump is pre-assembled on base, go to step#8.)
step#1 step#2
Locate this feature on the base. Drill (4) 7/16” [11mm] holes as
shown. Drill the center hole using the 4-1/2” [115mm] diameter hole
saw or to use a reciprocating saw, drill through the center dimple and
place the template (last page of instructions) on the top of the floor
Locate this feature on the base Drill a 1-1/2” [38mm] hole on the
lower left as shown and a 1-1/8” [29mm] hole on the upper right
as shown.