Satellite Hand Flush FF Bowl User Manual
Satellite TV Accessories

PN 20947 REV D
10-18-11
INSTRUCTIONS HAND FLUSH/FRESH FLUSH BOWL INSTALLATION
INTRODUCTION: Portable restrooms and accessory kits must be assembled according to approved assembly
procedures. Avoid variations in assembly procedures could adversely affect product life and warranty.
HARDWARE
TOOLS
*DRILL, *5/16 DRILL BIT, *3-1/2 HOLE SAW, *FLAT BLADE SCREWDRIVER, *UTILITY KNIFE,
*PENCIL, *Jig Saw
1. Drill Pump Mounting Holes:
Find the tank that you will be mounting the Hand Flush kit too. Measure to
center as shown and mark with pencil. With 3-1/2 hole saw, drill through tank wall. Center top plate (this
will be with #19173 pump) over 3-1/2 hole. Mark the (4) holes with pencil. Remove plate and drill (4) with
5/16 drill bit. On some tanks you may have to cut a slot in the opening for the hose and elbow clearance. Do
that at this time as shown.