Satellite Gender Indicator - Manual

P/N18534 / REVA 07/04
INSTRUCTIONS
MAXIM 3000® GENDER INDICATOR INSTALLATION
INTRODUCTION
Satellite portable restrooms and accessories must be assembled according to approved assembly procedures.
Variations in assembly could adversely affect product life and warranty.
HARDWARE:
TOOLS :
• DRILL ELEC/CORDLESS,
• 3/8" DRILL BIT,
•
FLAT HEAD SCREWDRIVER BIT
Using plate as a template, mark
holes position on door. Drill (2) 3/8” (0.375”) or 10
mm holes at marks being
careful to only drill through
outside wall of door. Using Jacknut wrench and bolt
provided, thread bolt through
wrench (in the direction
indicated on the tool) and into
jacknut. Push jacknut into
holes in door. Tighten the bolt
until there is marked resistance
in turning the bolt. (Caution:
Wrench is thin metal- protect
hand while using). Back out
bolt. Repeat above to install
second jacknut. Attach Gender Indicator plate
using (2) # 10-24 screws
supplied.
Note: All references to left and right are looking at the front of the unit.
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 / www.satelliteindustries.com