beautypg.com

Satellite Liberty User Manual

Page 7

background image

PN 18041-REV C

page 7

Install Paper guard.

Drill out 4 dimples in left
panel using a drill with a
¼” (.250”) [6 mm] drill bit,
at location below

Insert large flange #68
Alumium Rivet PN 11054
from the outside of the
panel.

Install paperguard
PN#17082 and 3/16"
back up washer PN#
11315 on the inside.

Insert the spindle PN#
16844 into the
paperguard. Note the
position of the hook.

Install Toilet Seat lid.
Install plastic bolt from seat lid
PN# 10570 hardware bag
through hinge into the tank

Thread plastic nut on from inside
of tank.

Phillips driver bit and drill can
be use to tighten. Be careful not
to over tighten nut.

Install Tank and Vent pipe.

Install vent tube PN#
13796 through the roof
opening by pushing
upward into roof hole and
twisting. Pull pipe down
behind handrail. Do not
insert into tank until
instructed.

Place tank PN# 14508
into the corner. Apply
pressure out against
panel while installing lag
screws for the outside of
unit.

Install lag screw PN#
13860 from outside. Drive
lag through forward dimple
in left panel 15-1/2" [39.37]
from the rear and 13-1/4"
[33.66cm] up from floor.

Drive lag through left
panel into dimple in
center of groove 17.00"
[43.18cm] up from floor.