Pilz PSEN me1.21S / 1AR - Manual (Page 3)

Installation and Operating Instructions
Date of issue: 22.02.2006 / Page 9 of 12
Document : 0800000458 / Version: 01 / 2196-06
Pilz GmbH & Co. KG, Sichere Automation, Felix-Wankel-Straße 2, D-73760 Ostfildern, Deutschland
Phone: +49 711 3409-0, Fax: +49 711 3409-133, E-Mail: [email protected], www.pilz.com
Template : 0850174292 Orig. 2
Mechanical data
Enclosure thermoplastic glass fibre reinforced Mechanical life 1 million switching cycles at
(UL94-VO) max. 600 cycles/hour
Cover thermoplastic glass fibre reinforced Mounting 4 M 5 screws ISO1207
(UL94-VO) ISO 4762
Actuator head thermoplastic glass fibre reinforced Tightening torque (max.) M= 2 Nm
and Zn-GD Conductor cross-section
Separate actuator St/PA / Zn-GD Termination cage clamp 1.5 mm² flex max.
Ambient air temperature -25 °C to +70 °C, -13 °F to +158 °F Cable entry 3 (M20X1.5)
Locking force F
Zh
max. 1500 N Mounting position any orientation
According to GS-ET-19 Weight approx. 0.3 kg (w/o actuator)
Actuating force 27 N min.
Actuating speed V=0.5 m/s max.
Electrical connection
The electrical connection shall only be carried out
by trained and qualified personnel!
I Release snap-shut terminal lid with a screwdriver
II Screw cable gland into the chosen entry, this will
‘break-out’ blind hole, remove plastic disk.
Connecting to cage clamp terminals:
1) Insert screwdriver (blade width 2.5 mm) in
lower opening
2) Turn 45°
3) Insert flex. cable in upper opening
(Max. 1.5 mm 2 cross-section)
remove screwdriver.
III Snap terminal chamber lid shut
Electrical data
Protection class IP 67 acc. to IEC 60529 Approvals see label on housing
Switch function 4 slow-action contacts max. BG (GS-ET-19) (applied for)
Rated insulation voltage U
i
250V cCSAus B300, R300 (applied for)
Utilization category AC 15 230V/2.5 A
Conventional thermal current I
the
2.5 A Standards VDE 0660 T100, EN 60947-1
Max. making current (4 contacts) 10 A VDE 0660 T200, EN 60947-5-1
Type of short-circuit protection 4 A gl IEC 60947-5-1 GS-ET-19
Solenoid
Actuating cycles permanent 600 / hour Solenoid power consumption PSEN me1 15 VA (0.5 s) inrush
Operating voltage PSEN me1 24 V AC/DC ≤ 1.4 VA (24 V) continuous
PSEN me1.1 24 V DC +24/110/230 V AC PSEN me1.1 56 VA (0.2 s) inrush
ON period 100 % duty cycle (to E1, E2) 1.1 VA continuous
Temperature class B (130 °C), (266 °F)
45
I
I
2
1