Bradford White ACCESSORY PACKAGES - Manual (Page 8)

Installing the Setback Control
-8-
Installing Setback Control
Step 5: Using the Setback Control Junction Box Assembly (already installed on water heater), snap the
Setback Control into the backplate connected to the Setback Control Junction Box Assembly, as shown in
Figure 5.
Figure 5
Powering the Water Heater and Setback Control
Step 6: Plug in the water heater and the transformer to power the Setback Control. This is shown in
Figure 6.
Figure 6
Transformer
Setback Control
Junction Box Assembly
Backplate
already installed Setback Control