Bradford White ACCESSORY PACKAGES - Manual (Page 50)

Setting a Temporary Temperature Hold
-50-
Temperature
digits are flashing
Figure 103
Figure 105
"Hold" flashes
for a Temporary Hold
Figure 104
If an alternate water temperature is required for a short period of time, follow the instructions in
this section to temporarily modify the Setback set water temperature.
Setting a New Water Temperature
Step 1: From the Home screen, press the UP (increase water temperature) or DOWN (decrease water
temperature buttons until the new desired water temperature is shown. This is shown in Figure 103.
Display of Temporary Hold Water Temperature
Step 2: A temporary hold will maintain the water heater setpoint at the new setting for two hours. Then,
the Setback Control will revert back to its programmed schedule. When the Setback Control is in a
temporary hold, the “Hold,” in the lower left corner of the display, will be flashing. This is shown in Figure
104.
Exiting a Temporary Hold
Step 3: To manually exit a Temporary Hold, press the RIGHT (Schedule) button, as shown in Figure 105.