Bradford White ACCESSORY PACKAGES - Manual (Page 12)

Remote Mounting the Setback Control
-12-
Prepare the Wires for Installation
Step 7: Strip approximately ¼” of the wire’s insulation from each end of the three wires. This is shown in
Figure 13.
Install Wire (A) – Backplate
Step 8: Using wire (A), insert one end into the top terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 14. Be sure that the wire already
located in this location is not dislodged.
Figure 14
Backplate
Wires Already
Installed
Wire (A)
Figure 13
Strip
Approximately ¼”
from Each End of
All (3) Wires