Bradford White ACCESSORY PACKAGES - Manual (Page 14)

Remote Mounting the Setback Control
-14-
Fasten Wire (B) into its Designated Location – Backplate
Step 11: Tighten the slotted screw in the middle terminal location on the backplate (located on the Setback
Control Junction Box Assembly). This is shown in Figure 17.
Figure 17
Install Wire (C) – Backplate
Step 12: Using wire (C), insert one end into the bottom terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 18. Be sure that the wire already located in
this location is not dislodged.
Figure 18
Wires Already
Installed
Wire (A)
Wire (B)
Backplate
Wire (C)
Slotted head
screwdriver
Backplate
Setback Control
Junction Box Assembly
Wire (B)
Wire (A)