Bradford White ACCESSORY PACKAGES - Manual (Page 15)

Remote Mounting the Setback Control
-15-
Fasten Wire (C) into its Designated Location – Backplate
Step 13: Tighten the slotted screw in the bottom terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 19.
Figure 19
Route Wires to Protective Plate
Step 14: Route all three wires to the Setback Control Protective Plate.
Slotted head
screwdriver
Backplate
Setback Control
Junction Box Assembly
Wire (B)
Wire (C)
Wire (A)