Bradford White ACCESSORY PACKAGES User Manual
Page 31
Setting the Setback
Control Schedule – Initial Set-up
-31-
"Mon" flashes
Figure 49
Figure 48
Once the Setback Control Start-up procedure has been performed, the Setback schedule must
be entered. This section gives step-by-step instructions on how to enter the Setback schedule.
Setting the Schedule
Step 1: From the Home screen, press the RIGHT (Schedule) button, as shown in Figure 48.
Select the Day
Step 2: Monday is flashing initially. Press the RIGHT (Next) button to proceed to the Wake Period for
Monday. This is shown in Figure 49. When the remaining days of the week are to be programmed, the
UP (increase day) or DOWN (decrease day) buttons must be used to change the day.
Select the Wake Period Start Time
Step 3: Press the UP (increase time) or DOWN (decrease time) buttons until the wanted time is shown.
This is shown in Figure 50.
Figure 50
Hour & minutes
digits are flashing