Bradford White ACCESSORY PACKAGES - Manual (Page 16)

Remote Mounting the Setback Control
-16-
Install Wire (A) – Protective Plate
Step 15: Using wire (A), insert one end into the top terminal location on the Protective Plate. This is
shown in Figure 20.
Fasten Wire (A) into its Designated Location – Protective Plate
Step 16: Tighten the slotted screw in the top terminal location on the Protective Plate. This is shown in
Figure 21.
Figure 21
Wire (A)
Figure 20 Protective
Plate
Wire (A)
Protective
Plate
Slotted head
screwdriver