Bradford White ACCESSORY PACKAGES - Manual (Page 18)

Remote Mounting the Setback Control
-18-
Install Wire (C) – Protective Plate
Step 19: Using wire (C), insert one end into the bottom terminal location on the Protective Plate. This is
shown in Figure 24.
Figure 24
Fasten Wire (C) into its Designated Location – Protective Plate
Step 20: Tighten the slotted screw in the bottom terminal location on the Protective Plate. This is shown
in Figure 25.
Figure 25
Protective
Plate
Slotted head
screwdriver
Wire (B)
Wire (C)
Protective
Plate
Wire (A)
Wire (B)
Wire (C)
Wire (A)