Bradford White ACCESSORY PACKAGES - Manual (Page 7)

Installing the Setback Control
-7-
Removal of Setback Control Protective Plate
Step 3: Remove the Setback Control Protective Plate from the Setback Control by pulling these
components in opposite directions, as shown in Figure 3. Retain the protective plate if the Setback
Control will be remote mounted.
Figure 3
Install Batteries
Step 4: Remove the battery holder from the Setback Control, and install (2) AAA batteries. Replace the
battery holder after the batteries are installed. This is shown in Figure 4.
Setback Control
Protective Plate
Setback Control
Battery Holder
Figure 4