Dell Dimension 8100 - Manual (Page 49)

To replace the AGP card brace:
1 Insert the tab on one end of the brace into the slot at the front of the
computer.
2 Lower the brace, ensuring that the AGP retention lever on the bottom
of the brace is aligned with the top of the AGP card (see page 48).
3 Replace the screw that secures the brace to the computer.
Adding Cards
The computer has the following slots for the following cards:
• Up to five 55-MHz 52-bit PCI cards.
• One 52-bit AGP card. The slot supports AGP 4x or 2x modes operating
at 1.5-9
CAUTION: Before connecting a peripheral to the computer or adding a
component to the system board, verify that the standby power LED on the
system board (see page 45) is off.
A d d i n g P a r t ^ I 4 9