Removing and replacing the agp card brace, Removing and replacing the agp card brace s – Dell Dimension 8100 User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To replace the front panel, fit the two retaining hooks into the recessed slots
at the bottom of the computer (see the preceding illustration), and then
rotate the top of the panel toward the computer until the tabs snap into the
slots on the panel.
Removing and Replacing the AGP Card
Brace
To access some components on the system board in the computer, you may
need to remove the AGP card brace:
1 Turn off the computer and peripherals, disconnect them from their
electrical outlets, and press and release the power button to drain the
power from the computer. Wait at least 5 seconds, and then remove
the computer cover (see page 42).
2 Remove the screw that secures the AGP card brace to the computer.
AGP card brace
slot
tab
AGP retention lever
AGP card
3 Rotate the brace up until it disengages from the slot at the front of the
computer. Then lift the brace away from the computer.
4 ^ I A d d i n g P a r t s