Char-Broil 4539937 - Manual (Page 8)

8
Ignitor Lighting
Do not lean over grill while lighting.
Light burners one at a time.
1. Turn all Gas Burner Control Valves.
2. Turn gas source or tank.
3. Open lid during lighting.
4. To ignite turn burner control valve to .
5. Push and hold
button until the burner
lights.
6. If ignition does not occur in 5 seconds, turn the burner controls
, wait 5 minutes, and repeat the lighting procedure.
7. Ignite remaining burners by repeating steps 4 through 6 for each
burner.
If ignition still does not occur, follow match-lighting instructions.
OFF
ON
ELECTRONIC IGNITOR
OFF
Main Burner Match-Lighting
Do not lean over grill while lighting.
1. Turn all Gas Burner Control Valves.
2. Open lid during lighting. Turn gas source or tank.
3. Place match into match holder (hanging from side of cart). Light
match, place into lighting hole for desired burner to light. The
lighting holes are located at the front of the cooking grates
between the emitter plate mounting brackets.
4. Push in and turn control knob to high position for the desired
burner to light. Be sure burner lights and stays lit.
5. If ignition does not occur in 5 seconds, turn the burner controls
, wait 5 minutes, and repeat the lighting procedure.
6. Ignite remaining burners by repeating steps 3 through 5 for each
burner.
OFF
ON
OFF
Side Burner Match-Lighting
Do not lean over grill while lighting.
1. Open lid during lighting. Turn
gas source or tank.
2. Place lit match near burner.
3. Turn sideburner knob to high
position.
Be sure burner lights and stays lit.
4. If ignition does not occur in 5 seconds,
turn the burner controls ,
wait 5 minutes, and repeat the lighting
procedure.
ON
OFF
CAUTION
Putting out grease fires by closing the lid is not possible.
Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may
result. If grease fire develops, turn knobs and LP cylinder
off.
Do not leave grill unattended while preheating or burning
off food residue on Hi. If grill has not been regularly
cleaned, a grease fire can occur that may damage the
product.
Safety Tips
- Before opening LP cylinder valve, check the coupling nut for
tightness.
- When grill is not in use, turn off all control knobs and LP cylinder
valve.
Never move grill while in operation or still hot.
- Maximum load for sideburner and side shelf is 10 lbs.
- The grease tray be inserted into grill and emptied after
each use. Do not remove grease tray until grill has completely
cooled.
- Clean grill often, preferably after each cookout. If a bristle brush
is used to clean any of the grill cooking surfaces, ensure no
loose bristles remain on cooking surfaces prior to grilling. It is
not recommended to clean surfaces while grill is hot.
- If you notice grease or other hot material dripping from grill onto
valve, hose or regulator, turn off gas supply at once. Determine
the cause, correct it, then clean and inspect valve, hose and
regulator before continuing. Perform a leak test.
- Keep ventilation openings in cylinder enclosure (grill Cart) free
and clean of debris.
- Do not store objects or materials inside the grill cart enclosure
that could block the flow of combustion air to the underside of
either the control panel or the firebox bowl.
- The regulator may make a humming or whistling noise during
operation. This will not affect safety or use of grill.
- If you have a grill problem see the of
your grill manual.
- If the regulator frosts, turn off grill and LP cylinder valve
immediately. This indicates a problem with the cylinder and it
should not be used on any product. Return to supplier!
-
must
- Use long-handled barbecue utensils and oven mitts to avoid
burns and splatters.
“Troubleshooting Section”
WARNING
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting
procedure. If the burner does not ignite with the valve
open, gas will continue to flow out of the burner and could
accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
Emitter Plate Brackets