Welch Allyn Propaq LT, Propaq CS and Micropaq monitor, Radio Configuration - Installation Guide - Manual (Page 7)

Radio configuration guide 80016835 Ver A 7
then the monitor displays the following screen:
To change the network name, make sure YES is highlighted, and press to display
the following screen:
Press or to highlight the desired network name, and then press . The
monitor turns itself off, turns on, and seeks to connect to a FlexNet network with the
new network name.
If the current network name is a custom name, the monitor displays the following
screen:
You cannot change a custom network name using the Network Name Menu. Press
to return to the Service Menu. To change a custom network name, see “Set an
SSID using the radio configuration tool” on page 14.