Welch Allyn Propaq LT, Propaq CS and Micropaq monitor, Radio Configuration - Installation Guide - Manual (Page 4)

4 80016835 Ver A Welch Allyn
Reset the Propaq LT monitor radio
It may be necessary to return the radio card to its default settings if:
• A network security setting was enabled that is not supported by the network
infrastructure.
• The network name was changed incorrectly.
• The default password was changed and forgotten.
To reset your monitor radio
1. Enter the Radio menu under the Service screen.
2. Press simultaneously .
3. Select Yes and press .
Table 1. Propaq LT NetName examples
Parameter Factory setting Possible values
Radio SSID
(NetName) com.protocol com.protocol, demo.protocol
com1.protocol, com2.protocol
com3.protocol, com4.protocol
com5.protocol, com6.protocol
com7.protocol, com8.protocol
com9.protocol, com10.protocol
com11.protocol, com12.protocol
com13.protocol, com14.protocol
com15.protocol, com16.protocol
com17.protocol, com18.protocol