Welch Allyn Propaq LT, Propaq CS and Micropaq monitor, Radio Configuration - Installation Guide - Manual (Page 5)

Radio configuration guide 80016835 Ver A 5
Micropaq Monitor
This procedure is for Micropaq monitors with software versions 1.80.00 or later.
To make any changes to your monitor radio card, access the monitor service menu.
To ensure that the monitor radio card is operational, wait 20 to 30 seconds after starting
the monitor before entering the service menu. You can also select the Network Status
screen under the System Information menu and wait for a valid firmware version to
appear.
To access the monitor service menu
1. Press to access the Main menu, and then repeatedly press until SERVICE
MENU is highlighted.
2. Press . The service menu appears.
When in the monitor service menu, you can set the authentication and encryption
scheme and the network name through the monitor user interface.
To set an authentication and encryption scheme
1. Press to select SET RADIO AUTH.
2. Press . The RADIO AUTH. menu appears.
A list of selectable schemes appears. The screen displays the scheme currently in
use. Press
to scroll through the options. The
▲and ▼ icons indicate more
available options. Press or to access them.
Note You cannot access the service menu if any patient cables are connected to the
monitor.